BMW SP Daten 2.49.0 V49 - The original factory firmware, designed to upgrade the software of electronic. Find K+DCAN & Enet Cables and the Bmw Software you need all in one place.

Here’s little tutorial on BMW E-series coding programs installation. Disclaimer: The document was translated from Korean. Ne rabotaet tahometr na audi 80 v3.

You are at your risk. Required files 1. BMW Coding Pack 3. BMW Coding Tool → Download Unpack and use 4. SP-DATEN → Download and use the data file for BASE and car! IAJg_VqYENXBCaGLS-AvFvhPSNEae2mp-aWtuYOHGv8 (E_coding.zip decryption key) Part II. Install the INPA program 1.

Materials (1) Coding required cable: (2) Programs required for coding: INPA / NCS Expert (3) Own vehicle information file (SP-Daten, SP-Daten capacity of 30 ~ 40GB per vehicle) 2. INPA program installation (1) INPA / K + D CAN drive installation If you unzip it, there are three folders in Step 1, 2, 3, and there are installation instructions, a description PDF document, 1) Copying the entire EC-Apps under the 01_Step1 directory to C: / 2) Run NFS / Entpackt / disk1 / SETUP.exe under the directory 01_Step1 Install If not, copy all of these NFS directories to C: / and install them) Note 1.

In Windows 8.1 32bit, copy the file under disk1 to C; / NTVDM automatically download and run) Note 2. If the program fails to install again after the installation fails, copy the previously copied C: / EC-Apps Clear all and copy again Select Window XP on the screen The remaining selection values User mode / Parametrienen einer neuen Configuration ohen Dafer / OBD / KeinApi-Trace / Kein IFH-TRACE / Komfor (.IPO) selection The first time you install regsvr32, the two *.ocx files will fail to register, but if you uninstall and reinstall the program you just installed from the control panel, the ocx file will be registered normally.

In particular, the message “The program is not installed properly” appears on Windows 7/8. Select the program installed correctly ” 3) Run INSTALL / Instprog.exe under the directory 02_Step2 (Copy and run under C: temp, but not on other drives) Select “ENGLISH” on the screen, press Continue / Continue and never change the folder or drive to install.

In the Configuration window Select “Bmw Group Rectification programs UK” → Continue EDIABAS 6.4.3 → Update INPA 5.0.1 → Update NCS Expert 3.0.8 → Check Complete → Continue 4) INSTALL / Instprog.exe under the 03_Step3 directory (Copy and run under C: temp, but not on other drives) 3) in the same way Old verstion delete → Yes 5) Overwrite inpa.ini under c: / EC-APPS / INPA / CFGDAT with inpa.ini in the INPA folder. Cable connections and port settings (1) Plug OBD cable into USB port and select manual drive installation 1) Install it as a drive under the drive under the INPA folder, and when installed, recognize USB Serial Port 2) In the USB Serial Port property, set Port Setting / Advanced / Com Port No. 1, Response Time 1 (2) Run Drive_D_CAN_USB / OBDSetup.exe under INPA directory and reboot installation complete (3) Confirmation of installation: Execute c: /EC_Apps/INPA/BIN/inpaload.exe and Battery / Ignition If you see two black dots on the installation succeeded Part III. Installing from BMW Coding Pack 1.